9.6.2.2
Removing the FBU with the holder
Figure 125: Removing the FBU with the holder
Ê Carefully disconnect the FBU cable from the RAID controller.
Ê Lift up the green locking handle on the FBU holder while sliding the FBU
holder in the direction of the arrow as far as it will go.
I
After that, the hooks on the air duct will rest in the wide ends of the
keyhole slots on the holder.
Ê Lift the FBU holder from the riser card holder.
RX2540 M1
Upgrade and Maintenance Manual
Expansion cards and backup units
221