Removing A 3.5-Inch Hdd Module - Fujitsu PRIMERGY RX2540 M1 Upgrade And Maintenance Manual

Hide thumbs Also See for PRIMERGY RX2540 M1:

Table of Contents

All data on all HDDs in the array will be lost! Be sure to back up your

data before deleting a RAID array.

For further information, please refer to the "ServerView Suite RAID

Management" user guide and manuals of RAID controller.

Removing a 3.5-inch HDD module

Figure 25: Removing a 3.5-inch HDD module

Ê Press the green locking clip (1) and fully open the locking lever (2).

Thereby, the HDD module is pushed out of its drive bay by about 1 cm

and disconnected from the SAS / SATA backplane.

Ê Wait about 30 seconds to allow the hard disk drive to spin down.

Ê Pull the HDD module completely out of its bay (3).

Upgrade and Maintenance Manual

Hard disk drives / solid state drives