Concluding Steps - Fujitsu PRIMERGY RX2540 M1 Upgrade And Maintenance Manual

Hard disk drives / solid state drives
Figure 54: Connecting SAS cables to the expander board
Figure 55: Connecting SAS cables to the system board
Ê Connect the two SAS cables to the SAS expander board:
– (1) from SAS controller connector MLC1 to SAS expander board
– (2) from SAS controller connector MLC2 to SAS expander board
7.3.3.6

Concluding steps

"Installing the fan box" on page 156
Ê
"Reassembling" on page 61
Ê
Ê Insert all HDD/SSD modules, see section
on page 115
I
Make sure that you reinstall the HDD/SSD module in the bay it was
located before the HDD backplane replacement.
"Connecting the server to the power source" on page 66
Ê
"Switching on the server" on page 67
Ê
142 Upgrade and Maintenance Manual
"Installing 3.5-inch HDD modules"
RX2540 M1