Table of Contents
Advertisement
Hard disk drives / solid state drives
7.1
Basic procedures
– Solid state drives (SSDs) are always equipped before installing hard disk
drives
– Hard disk drives / solid state drives with different capacities are installed
from highest to lowest capacity.
– Hard disk drives with different rotation speeds are installed from highest to
lowest speed.
– When installing hard disk drives with different bus technologies (SAS or
SATA), first install SAS drives and then SATA drives.
– Please refer to sections
a complete overview of the mounting sequence.
– Install dummy modules into unused HDD bays.
I
The mounting order described above is only relevant for the factory
manufacturing process. In case of upgrading a system you need not
consider this mounting sequence.
7.2
3.5-inch cage configurations HDD / SSD
7.2.1
Mounting order for 3.5-inch HDDs
Maximum configuration: 8x 3.5-inch HDDs
Basic information
– If only one HDD module is installed, the HDD module will be installed in
position 1. Empty bays must be equipped with a dummy module.
112
"Mounting order for 3.5-inch HDDs" on page 112
Upgrade and Maintenance Manual
for
RX2540 M1
Advertisement
Table of Contents
