Removing Riser Module 2 (Hl); Preliminary Steps; Removing The Riser Module 2 (Hl) - Fujitsu PRIMERGY RX2540 M1 Upgrade And Maintenance Manual

Expansion cards and backup units
Ê If applicable, "Updating RAID controller firmware" on page
Ê If applicable, "Enabling Option ROM scan" on page
"Enabling SVOM boot watchdog functionality" on page 86
Ê
"Enabling BitLocker functionality" on page 92
Ê
9.5.4

Removing riser module 2 (HL)

Upgrade and Repair Unit
(URU)
Tools: Phillips PH2 / (+) No. 2 screw driver
9.5.4.1

Preliminary steps

Ê If applicable, "Locating the defective server" on page 51
"Disabling or suspending BitLocker functionality" on page 69
Ê
"Shutting down the server" on page 53
Ê
Ê Remove all external cables from the expansion card to be removed.
"Disconnecting power cords" on page 54
Ê
"Getting access to the component" on page 55
Ê
Ê If applicable, disconnect internal cables from the expansion board.
9.5.4.2

Removing the riser module 2 (HL)

Ê If applicable, "Removing an SFP+ transceiver module" on page
202 Upgrade and Maintenance Manual
81.
82.
Hardware: 5 minutes
Software: 5 minutes
175.
RX2540 M1