Expansion cards and backup units
9.5.2.6
Insert the riser module 1 (HL)
Optionally you can install the riser module. In this case proceed as follows:
Ê Install the riser module as described in section
(HL)" on page
9.5.2.7
Concluding steps
"Reassembling" on page 61
Ê
"Connecting the server to the power source" on page 66
Ê
"Switching on the server" on page 67
Ê
"Enabling BitLocker functionality" on page 92
Ê
9.5.3
Installing an expansion card in riser module 2
Upgrade and Repair Unit
(URU)
Tools: Phillips PH2 / (+) No. 2 screw driver
9.5.3.1
Preliminary steps
"Disabling or suspending BitLocker functionality" on page 69
Ê
"Disabling SVOM boot watchdog functionality" on page 70
Ê
"Shutting down the server" on page 53
Ê
"Disconnecting power cords" on page 54
Ê
"Getting access to the component" on page 55
Ê
9.5.3.2
Installing a riser card
Ê Install the riser card as described in section
page
187.
196
190.
Upgrade and Maintenance Manual
"Installing the riser module 1
Hardware: 5 minutes
Software: 5 minutes
"Installing a riser card (HL)" on
RX2540 M1