Table of Contents
Advertisement
"Shutting down the server" on page 53
Ê
"Disconnecting power cords" on page 54
Ê
"Getting access to the component" on page 55
Ê
9.8.4.2
Removing the DynamicLoM module
"Removing the DynamicLoM module" on page 260
Ê
9.8.4.3
Installing the DynamicLoM module
"Installing the DynamicLoM module" on page 256
Ê
9.8.4.4
Concluding steps
"Reassembling" on page 61
Ê
"Connecting the server to the power source" on page 66
Ê
"Switching on the server" on page 67
Ê
Ê Inform the customer about changed WWN and MAC addresses. For further
information, refer to section
on page
93.
"Updating the NIC configuration file in a Linux environment" on page 90
Ê
"Configuring LAN teaming" on page 97
Ê
"Enabling SVOM boot watchdog functionality" on page 86
Ê
Ê Start Emulex PXESelect Utility
Ê Press the [Ctrl] + [P] keys during POST phase.
Ê Select Controller #1 Configuration and press the [Enter] key.
Controller Model: OCI14000-LOM
Firmware Version: 10.2.265.3
IPL Version: LS2FFTE0
Multichannel: DISABLED
Personality: NIC
SRIOV: DISABLED
RX2540 M1
"Looking up changed MAC / WWN addresses"
Upgrade and Maintenance Manual
Expansion cards and backup units
263
Advertisement
Table of Contents
