Installing The New Expansion Card; Connecting Cables To The Expansion Card; Connecting A Battery Backup Unit To The Expansion Card; Concluding Steps - Fujitsu PRIMERGY RX2540 M1 Upgrade And Maintenance Manual

Ê If applicable, remove the riser module 2 as described in section
the riser module 2 (HL)" on page
Ê Remove the expansion card as described in section
expansion card (HL)" on page
9.5.5.3

Installing the new expansion card

Ê Install the new expansion card as described in section
expansion card in a riser module (HL)" on page
Ê If applicable, install the riser module 1 as described in section
riser module 1 (HL)" on page
Ê If applicable, install the riser module 2 as described in section
riser module 2 (HL)" on page
9.5.5.4

Connecting cables to the expansion card

Ê If applicable, connect internal cables to the expansion card.
I
For a complete cabling overview, please refer to section
cables" on page
9.5.5.5

Connecting a battery backup unit to the expansion card

Ê If applicable, connect a FBU to the expansion card as described in section
"Installing a FBU" on page
9.5.5.6

Concluding steps

"Reassembling" on page 61
Ê
Ê Reconnect all external cables to the replaced expansion card.
"Connecting the server to the power source" on page 66
Ê
"Switching on the server" on page 67
Ê
"Enabling replaced components in the system BIOS" on page 86
Ê
Ê If applicable, inform the customer about changed WWN and MAC
addresses. For further information, refer to section
MAC / WWN addresses" on page
Ê If applicable,"Updating RAID controller firmware" on page
RX2540 M1
202.
194.
190.
200.
411.
237.
93.
Upgrade and Maintenance Manual
Expansion cards and backup units
"Removing an
"Installing an
187.
"Looking up changed
"Removing
"Installing the
"Installing the
"List of used
81.
207