Konica Minolta bizhub C650 Service Manual page 1184

Field Service Ver. 7.0 Jun. 2008
[4]
[1]
[1]
[2]
A07RF2C508DA
[1]
[2]
[3]
A07RF3C546DA
[3]
[1]
[2]
A
A07RF3C547DA
8. Mechanical adjustment
8. Remove five screws [1] and remove
stapler unit cover [2].
9. Check to see if the actuator of the
alignment plate home sensor /Up is
aligned with the home position.
10. Check to see if the actuator [3] of the
alignment home sensor /Lw [2] for
the alignment plate /Lw [1] is aligned
with the home position.
11. Set the paper that is larger than A4S
in the stacker section, and then
make the alignment plate /UpRr [1]
and the alignment plate /LwRr [2]
contact with the paper [3] and check
to see if the they are aligned. Also,
check to see if the distance A
between the alignment plate /LwRr
[2] and the alignment plate /LwFr [4]
is within a standard value.
Standard value: A = 335.5
12. When the value is not within the
standard value, perform the following
adjustment.
+1.5
mm
-0.5
87