Konica Minolta bizhub C650 Service Manual page 1186

Field Service Ver. 7.0 Jun. 2008
8.7 Staple position adjustment (flat-stapling)
• Conduct this adjustment when the staple position is not within the standard value.
• Be careful not to let FS fall down when removing FS from the main body
and pulling out the stacker unit from FS. It may cause the injury.
8.7.1 For FS-517/FS-518
5
1. Make a copy in the staple mode.
1-point tilted staple
A
5
5
1-point parallel staple
B
2-point staple
C
CAUTION
2. Check the staple position on the
<For FS-517>
• 1-point tilted staple
Specification A: 8.5 ± 3.0 mm
•
1-point parallel staple
Specification B: 8.5 ± 3.0 mm
•
2-point staple
Specification C: 8.5 ± 3.0 mm
<For FS-518>
• 1-point tilted staple
Specification A: 10 ± 3.0 mm
•
1-point parallel staple
Specification B: 10 ± 3.0 mm
•
2-point staple
Specification C: 10 ± 3.0 mm
NOTE
• In the flat-stapling, the edge of the
paper and the line [1] connecting 2
staples should be in parallel.
3. If the staple position is out of the
A07RF3C550DB
8. Mechanical adjustment
copy is within the specified range.
specified range, make the following
adjustment.
89
5