8. Mechanical adjustment
8.11 Adjusting the folding pressure (only FS-608)
• Be careful not to let FS fall down when removing FS from the main body
and pulling out the stacker unit from FS. It may cause the injury.
• Conduct this adjustment if you want to change the power of the pressure of the folding
roller.
1. Remove the finisher.
See P.31
2. Remove the rear cover.
See P.26
3. Open the front door.
4. Remove the stacker unit cover.
See P.30
[1]
C
B
A
[1]
104
CAUTION
A
B
C
C
B
A
A07RF3C556DA
C
B
A
A07RF3C557DA
Field Service Ver. 7.0 Jun. 2008
5. Change the hook holes where the
two front pressure springs [1] are
hooked.
A: Weak
B: Intermediate
C: Strong
6. Change the hook holes where the
two rear pressure springs [1] are
hooked.
A: Weak
B: Intermediate
C: Strong
NOTE
• Hook the 4 pressure springs [1] on
the hook holes of the same mark.