Pi Tilt Adjustment (With Pk-512/Pk-513 Installed) - Konica Minolta bizhub C650 Service Manual

Field Service Ver. 2.0 Aug. 2007
8.2

PI tilt adjustment (with PK-512/PK-513 installed)

• Conduct this adjustment if the edge of the paper and the punch hole position of the paper
fed from PI is not in parallel.
1. Set three sheets of paper in the tray of the PI, and then feed them in the punch mode
as samples.
[1]
[3]
[5]
6. Repeat step 1 to 5 until the tilt of the punch holes is corrected.
2. Fold the sheets in half and check the
[2]
A07VF3C501DA
3. Open the front door of finisher, and
4. Adjust the guide plate [1] in accor-
5. Tighten the screw [2].
[1]
[2]
[4]
A07VF3C502DA
8. Mechanical adjustment
tilt of the punch holes.
[1]: The front is wider
[2]: The back is wider
then loosen the screw [2] of the
guide plate [1].
dance with the misalignment of the
punch holes by referring to the mark
[3].
The back is wider: Move to [4]
The front is wider: Move to [5]
25