Konica Minolta bizhub C650 Service Manual page 1147

4. Other
[4]
[1]
5
[2]
[3]
50
5
[5]
[2]
[3]
A07RF2C523DA
[1]
A07RF2C524DA
Field Service Ver. 7.0 Jun. 2008
B. Installation procedure
1. Tighten the wire mounting plate [1] of
the new lift wire on the lift stay [2]
with two screws [3] temporarily.
NOTE
• The lift wire should be placed with
the short side [4] to the bottom and
the long side [5] to the top.
2. Fasten the wire end of the lift wire
with the inner wire end hole of the lift
pulley /Lw [1]. Then, draw the lift wire
through the notch [2] and wind it 5.5
turns (for FS-517/FS-518) / a little
less than 5 turns (for FS-608) from
inside to outside around the lift pulley
with no slack, and then insert the lift
pulley /Lw [1] into the shaft so that it
coincides with the pin [3].