Punch Unit Vertical Position Adjustment - Konica Minolta bizhub 601 User Manual

Utility mode
– Check that the vertical position of the punched holes was adjusted.
– If more adjustment is necessary, repeat steps 6 through 9.
Note
Set the value by mm. Refer to the conversion rate below.
1 inch = 25.4 mm
11.6.4

Punch Unit Vertical Position Adjustment

The vertical position of punched holes when printing with a Punch setting can be adjusted for each paper
size.
Note
[Punch Unit Vertical Position Adjustment] appears only if optional Z folding unit is installed.
For details on the Punch settings, refer to
0 Before making any adjustments, use a Punch setting to print a sample copy. Perform the adjustment
while checking the sample that was created.
1
Display the Administrator Settings screen.
– For details on displaying the Administrator Settings screen, refer to
Settings screen" on page
2
Touch [1 System Settings].
The System Settings screen appears.
3
Touch [7 Expert Adjustment].
The Expert Adjustment screen appears.
4
Touch [5 Finisher Adjustment].
The Finisher Adjustment screen appears.
5
Touch [4 Punch Unit Vertical Position Adjustment].
The Punch Unit Vertical Position screen appears.
6
Touch the button for the paper size to be adjusted.
If the paper size to be adjusted is not displayed, touch [↑] and [↓] until the desired paper size is
–
displayed.
7
Check the sample copy for the punch positions and for the center of the paper.
– If the punch positions are too far above the center of the paper, touch [+] under "Adjust Value" to
increase the adjustment (between 0.1 mm and 5.0 mm).
751/601
"Punching holes in copies (Punch settings)" on page
11-36.
"Displaying the Administrator
11
2-62.
11-44