Removal & Installation Procedure
1. Remove the belt pulley.
Installation Notice
Tightening Torque
Notice
Pull the tensioning pulley clockwise as shown in the figure.
2. Disconnect the hydraulic pipe of the power steering pump
and drain the oil.
3. Unscrew the bolts (arrows) and remove the steering pump.
Installation Notice
Tightening Torque
4. Remove the compressor after disconnecting the wiring
connector and refrigerant pipe of A/C compressor.
Notice
Discharge all the refrigerant before removing the pipes.
40.5 - 49.5 Nm
22.5 - 27.5 Nm
M162 ENGINE MECHANICAL 1B1-19