Crankshaft Front Radial Seal - Daewoo KORANDO Service Manual

1B1-44 M162 ENGINE MECHANICAL

CRANKSHAFT FRONT RADIAL SEAL

Preceding Work : Removal of belt pulley and vibration damper
Tools Required
601 589 03 14 00 Sleeve
Replacement Procedure
1. Remove the radial seal with a screw driver.
Notice
Use a clean cloth not to damage the radial seal mounting
hole and the crankshaft.
2. Coat the radial sealing lip with engine oil.
3. Using the sleeve, assemble the radial seal .
4. Align the sleeve groove and the woodruff key and tighten
the center bolt until the center bolt and the damper disk
stop in the movement.
Installation Notice
Tightening Torque
5. Remove the sleeve and install the belt pulley and the
vibration damper.
6. Check for leaks while operating the engine.
1st step 200 - 220Nm
2nd step 90° + 10°
1 Center Bolt (M18 x 50)
................................ 1st step 200-220 Nm
2 Center Bolt Washer
3 Sleeve (Special Tool)
4 Crankshaft Front Seal
5 Key
2nd step 90° +10°