Daewoo KORANDO Service Manual page 906

5. Remove the drive pinion lock nut. Disassemble the parts of
the drive pinion.
Assembly Procedure
1. Clean the all parts and check the followings.
Check the ring gear and drive pinion for wear or damage.
If damaged, replace it as set.
Check the bearing for sticks, wear, noise or turning
resistance.
Check the side gear, pinion, pinion shaft and thrust
washer for wear or damage.
Check the differential carrier for crack or wear (bearing
contact surface). Check the gear case for crack.
2. Assemble the parts of the drive pinion.
Tightening Torque of The
Pinion Lock Nut
3. Assemble the parts of the differential carrier.
Tightening Torque of The
Ring Gear Bolts
240 - 310 Nm
75 - 90 Nm
REAR DRIVE AXLE 3D-13