Daewoo KORANDO Service Manual page 261

1B2-72 M161 ENGINE MECHANICAL
Tools Required
111 589 01 59 00 Supporting Bar
111 589 18 61 00 Lever Pusher
111 589 25 63 00 Thrust Piece
116 589 06 63 00 Magnetic Finger
Removal & Installation Procedure
1. Place the supporting bar (12) and the slide (9) at the
camshaft bearing cap (Nos 1 & 7/8&14) and tighten them
with the bearing cap bolt.
Installation Notice
Tightening Torque
2. Turn the crankshaft to position the each cylinder piston at
TDC.
Mark on The Vibration Damper
OT
UT
Notice
Remove the valve spring only at TDC.
Always rotate the crankshaft by holding the chain to
prevent from timing chain damage and tangling, and for
smooth rotation.
3. Remove the valve tappet (1) using the magnetic finger.
4. Install the leakage tester connecting hose to the spark plug
hole.
5. Install the engine lock to the ring gear to prevent the
crankshaft from rotating.
6. Blow up with compressed air.
22.5 - 27.5 Nm
Supporting Bar 111 589 01 59 00
Cylinder
1, 4
2, 3