Daewoo KORANDO Service Manual page 486

Removal & Installation Procedure
1. Remove the timing case cover.
2. By inserting a round bar (6) approx. 0.7m from the back to
the front side through the oil gallery, knock out the steel
balls (1,3).
Notice
Be careful not to damage the bores of the steel balls.
3. Thoroughly clean the bores of steel balls.
4. Place the steel ball (3) onto the drift (7) with a little grease
and position to the bore and then tap until the drift stops.
5. Place the steel ball (1) onto the drift (7) with a little grease
and position to the bore and then tap until the drift stops.
6. Warm up the engine and check the oil for leaks.
OM600 ENGINE MECHANICAL 1B3-185
6 Shop-made tool
Drift 601 589 08 15 00
Drift 601 589 08 15