Daewoo KORANDO Service Manual page 942

4E-4 REAR DISC BRAKES
UNIT REPAIR
REAR DISC BRAKE
Inspection Procedure
1. Clean all components and visually check the followings.
Check the cylinder and piston for wear, rust or damage.
Check the caliper body and guide pin for wear, damage
or crank.
Check the pads for uneven wear or oiliness.
Check the boots for damage or tear.
2. Measure caliper housing inner diameter.
Item
With PBR
With MANDO
3. Measure pad thickness.
Standard
9.5 mm
Notice
Always change the all pads on one wheel at a time.
4. Measure rotor disc thickness.
Standard
10.4 mm
5. Check the rotor disc for score or runout.
Standard Wear Limit
f 40.5 mm f 41.5 mm
f 38.2 mm f 39.2 mm
Wear Limit
2.0 mm
Wear Limit
9.3 mm