Installation Procedure - Daewoo KORANDO Service Manual

1B1-60 M162 ENGINE MECHANICAL
8. Unscrew the intake side bolts (8, 11, 13, 14) and the exhaust
side bolts (1, 4, 6, 7).
9. Loosen the remaining bolts and unscrew the intake and
exhaust side camshaft bearing cap bolts.
Notice
Number the camshaft bearing cap bolts when removing
them, so that they don't get mixed up.
10. Remove the intake and exhaust camshafts.

Installation Procedure

1. Turn the crankshaft and position the No. 1 cylinder piston
at BTDC 30°.
Notice
Turn the crankshaft in the direction of engine rotation.
2. Install the exhaust camshaft bearing caps (2, 3, 5) and the
intake camshaft bearing caps (9, 10, 12). Tighten the bolts
with specified torque and install the remaining bearing caps.
Notice
Tightening Torque
Install the bearing caps according to the numbers on the
bearing caps.
3. Turn the camshaft using the wrench (special tool) so that
the intake camshaft adjustment hole lines up with the cylinder
head upper side (3 o'clock direction at the intake, 9 o'clock
direction at the exhaust).
Notice
Turn the crankshaft and adjust it to OT so that no. 1 cylinder's
piston would be at TDC.
22.5 - 27.5 Nm