Daewoo KORANDO Service Manual page 282

Inspection
1. Measure the basic bore of the connecting rod bearing.
Notice
If the basic bore exceeds the value of 51.614mm, replace
the bearing or check the connecting rod.
2. Check connecting rod bolts.
Length When New (L)
Max. Length (L)
Tightening Torque
Notice
If the length exceeds max. length, replace it.
3. Check the assembly mark(indication // or number:arrow) of
the connecting rods and the bearing cap when installing.
Notice
Make sure it doesn't exceed over 4g with other
connecting rods when replacing the connecting rods.
Check if the connecting rod and the bearing cap are
accurately seated on the groove when replacing the
bearing.
51.7 - 52 mm
52.9 mm
1st step 40 + 5 Nm
2nd step 90°+10°
M161 ENGINE MECHANICAL 1B2-93