Table of Contents
Advertisement
8. Thoroughly clean the oil gallery.
9. Select a proper new bearing shells with reference to table.
10. Coat the new bearing shells with oil and insert into the
crankcase and into the crankshaft bearing caps.
Notice
Do not mix up upper and lower crankshaft bearing shells.
11. Install the bearing caps according to marking and tighten
the 12-sided stretch bolts.
Tightening Torque
Notice
No. 1 is vibration damper side.
12. Measure crankshaft bearing diameters (E).
13. Measure at 3 points (A, B and C) and if the average value
of B and C is less than A's value, the average value of B
and C is the mean value and if more than A's value, A's
value is the mean value.
14. Measure crankshaft bearing journal diameter (F).
Notice
When measured in A and B, the runout should not exceed
0.010mm.
35 - 40 Nm
Extension 366 589 00 21 05
OM600 ENGINE MECHANICAL 1B3-89
Advertisement
Chapters
Table of Contents
