Daewoo KORANDO Service Manual page 255

1B2-66 M161 ENGINE MECHANICAL
Tools Required
000 589 01 10 00 Box Wrench Insert
104 589 01 01 00 Spanner
Removal & Installation Procedure
1. Turn the crankshaft and position the No.1 cylinder piston at
ATDC20°.
2. Put the alignment marks (arrows) on the camshaft sprocket
and the timing chain.
3. Remove the chain tensioner.
Installation Notice
Tightening Torque
4. Remove the exhoust camshaft sprocket.
Installation Notice
Tightening Torque
Notice
The sprocket bolt is designed to be used only once, so
always replace with new one.
5. Take off the timing chain from intake camshaft sprocket,
and secute it not to fall down into the timing gear case.
6. Using the wrench (7), turn the camshaft until there is no
resistence in camshaft bearing area.
Screw Plug
Tensioner Assembly
72 - 88 Nm
1st step 35 - 45 Nm
2nd step 85° - 95°
40 Nm