Daewoo KORANDO Service Manual page 631

1F1-62 M162 ENGINE CONTROLS
Test
1. Maintain the normal temperature and idling state by
operating the engine.
2. Connect the ECU terminal No.11 and No.34 and check for
normal operation through the output waves using the
scanner.
Notice
Test during purge control switchover valve operation after
the minimum of 1 minute after the engine turned on.
3. Connect the ECU terminal No.34 and No.10 and check for
current consumption during the ignition switch ON.
Specified Value
4. Remove the line to canister and measure the pressure with
the vacuum pressure gauge.
Specified Value
Notice
Test while at normal temperature and at idling state by
operating the engine.
0.3 - 0.5
> 50mbar
(after approx. 1min.)
purge switchover valve
operates at this time
Purge switchover valve output wave