Editing Tags; Deleting Tags - KEP MMI-1500 Installation & Operation Manual

2. Click the Add ... button. The Tag Dialog pops up. Fill in
the Tag Name, Address Type, Device Type and Device
address.
(Example shown to the right.)
Item Description
A brief name for the tag. Note: Only the first 18 characters are displayed in dialogs.
Tag Name
Select Bit or Word. This determines the type of Parts that have access to this tag.
Address Type
Prefix for the data type. This is dependent on PLC type.
Device Type
Data bit/word numerical address. Note: Extended Addressing is allowed when applicable.
Address
Saves tag to Tag Library and closes dialog.
OK
Close dialog without saving the entered information.
Cancel
3. Click OK to add the Tag to the Tag Library.
Note: Any changes that you make to tags are not saved until you save your project.

7.7.2 Editing Tags

Call up the Tag Library, select the tag to edit and click on the Modify ... button. Change the fields as desired. If the Address
is changed, all places where the tag is used in the project are changed.
Note: If the Tag Name or Address Type fields are changed, all places where that Tag is used are changed to the first
Tag in the Tag Library. Once OK is clicked, this happens. This action cannot be recovered using the Undo command.

7.7.3 Deleting Tags

Call up the Tag Library, select the tag to delete and click on the Delete button.
Note: All places where that Tag is used are changed to the first Tag in the Tag Library. Once Delete is clicked this
happens. This action cannot be recovered using the Undo command.
Tag Library with example tag
73