Industrial Indexing Systems, Inc; 16.14 Iis Esc (Industrial Indexing Systems - KEP MMI-1500 Installation & Operation Manual

16.14 IIS ESC (INDUSTRIAL INDEXING SYSTEMS)

16.14.1 HMI Setting
Communication parameters must be set the same as those of the PLC. The following settings are recommended.
Parameter Recommended Setting
Serial I/F port RS232
Baud rate 19200
Parity None
Data bits 8
Stop bits 1
HMI station No. 0
PLC station No. 255
Comm. delay (10msec) 0
16.14.2 Controller Setting
Communication parameters must be the same as those of the MMI.
App Port set Mode: ESC Packet Protocol 19200, None, 8, 1
Compatible PLC
Emerald EMC-2000 controller
16.14.3 Wiring
Wiring for cable connections using Emerald EMC-2000 Controllers with RS232 RJ-12 socket ports.
16.14.3.1
KEP Part#: (Not Available) (D-Sub 9 Male Socket to RJ-12 Male Cable)
HMI PLC[RS-232]
2 TXD
3 RXD
5 GND
Note: Graphic representation may not reflect the actual appearance of the finished cable.
Connect to Emerald EMC-2000 Controller with RS232 Port
3 RXD
5 TXD
4 GND
Shield Earth Ground
Notes
Options: RS232, RS485 – Dependant on PLC hardware
Options: 9600, 19200, 38400, 57600, 115200 - Must match PLC port
setting
Options: Odd, Even, None - Must match PLC port setting
Options: 7, 8 - Must match PLC port setting
Options: 1, 2 - Must match PLC port setting
Not used
Not used
Request delay: 0~999 @10 milliseconds. Use when the PLC requires a
delay between requests. Not implemented in simulation mode.
232