Keyence Kv-16Dt; Keyence Kv/Visual Kv [Pds] - KEP MMI-1500 Installation & Operation Manual

16.16 Keyence KV/Visual KV [PDS]

16.16.1 HMI Setting
Communication parameters must be set the same as those of the PLC. The following settings are recommended.
Parameter
PLC type
Serial I/F port
Baud rate
Parity
Data bits
Stop bits
HMI station No.
PLC station No.
Comm. delay (10msec) 0
16.16.2 PLC Setting
Communication parameters must be the same as those of the MMI.
Compatible PLCs
KV series PLC: KV-10, KV-16, KV-24 and KV-40
16.16.3 Wiring
16.16.3.1 Wiring for cable connections using Keyence KV Series with RS232 RJ-12 Socket ports.
KEP Part#: SMICKEY-05 (D-Sub 9 Male Socket to RJ-12 Male Cable)
HMI PLC[RS-232]
2 TXD
3 RXD
5 GND 9
Recommended Setting
KEYENCE KV/Visual KV
[PDS V2.00]
RS232
9600
Even
8
1
0
0
Connect to Keyence KV Series CPU with RS232 Port
4 RXD
3 TXD
2 GND
Shield Earth Ground
Notes
Keyv_16DT.pds driver must be present in \drivers folder
Must match PLC port setting
Options: Odd, Even, None - Must match PLC port setting
Must match PLC port setting
Must match PLC port setting
Not used
Not used
Request delay: 0~999 @10 milliseconds. Use when the PLC requires a
delay between requests. Not implemented in simulation mode.
235