Samsung Spc-10 - KEP MMI-1500 Installation & Operation Manual

16.37 Samsung SPC-10

16.37.1 HMI Setting
Communication parameters must be set the same as those of the PLC. The following settings are recommended.
Parameter Recommended Setting Notes
Serial I/F port RS485 2W
Baud rate 9600
Parity None
Data bits 8
Stop bits 1
HMI station No. 192
PLC station No. 255
Comm. delay (10msec) 0
16.37.2 PLC Setting
Communication parameters must be the same as those of the MMI
Compatible with:
Samsung SPC-10
16.37.3 Wiring
16.37.3.1 Wiring for cable connections using Samsung SPC-10 CPU with RS485 Round 8 pin MiniDIN ports.
KEP Part#: (Not Available) (D-Sub 9 Female Plug to 8 pin MiniDIN Male Plug Cable)
HMI PLC[RS-485]
1 RXD/TXD-
2 RXD/TXD+
5 GND
Note: Graphic representation may not reflect the actual appearance of the finished cable.
16.37.4 Device address
Bit/Word Type Address Format
B R
B K
B M
B F
W W
Must match PLC port setting
Must match PLC port setting
Must match PLC port setting
Must match PLC port setting
Request delay: 0~999 @10 milliseconds. Use when the PLC requires a
delay between requests. Not implemented in simulation mode.
Connect to Samsung SPC-10 CPU's RS-485 Port
6 RXD/TXD-
7 RXD/TXD+
5 GND
Shield Earth Ground
Range
dddd(dd) dddd: 0~9999 (dd): 0~15
dddd(dd) dddd: 0~9999 (dd): 0~15
dddd(dd) dddd: 0~9999 (dd): 0~15
dddd(dd) dddd: 0~9999 (dd): 0~15
dddd dddd: 0~9999
Notes
Input / Output
Keep relay
Internal relay
Special relay
Data register
284