Debugging With Easywindow - KEP MMI-1500 Installation & Operation Manual

This PLC Only Support Write
<##> Words of Word Data
Touch Queue Full
Width and Height Must Be same
with Window 4
White Board Support Popup Style
Only
Window <##> was opened As a
common Popup Window
*Message can be customized by "System Message Part".

11.2 Debugging with EasyWindow

EasyBuilder projects can be debugged with the EasyWindow utility. EasyWindow is the utility that is used to run projects in
Simulation mode. There are two simulation screen formats; a graphic simulation that looks like the bezel of an HMI unit with
the simulation window, or a Window frame with menu and the simulation window.
For the Graphic Simulation, right click to bring up the EasyWindow menu.
For the Windows Frame Simulation, selections can be made right from the menu bar.
Use the Emulator setting menu item to change the simulation appearance.
Note: Menu items below the Emulator setting are used for project documentation. (See
section on Project Management and Documentation.)
A part is attempting to write more data to the PLC than the driver can handle.
Reduce the number of words assigned to that part or adjust the Block Pack.
System has run out of memory – check factory
Attempting to change the Fast Select Window, via Function Key, with a window
that is not the same size as Window 4.
The Message Board window can only be called up as a Direct, Indirect or Popup
window.
Attempting to open a full screen Base window number <##> as a Popup window.
109