Mitsubishi Fx0N/2/2N Com, Fx0N/Fx2, Fx2N, Fx2N D(Bit); Mitsubishi Fx0N/2/2N Com, Fx0N/Fx2, Fx2N Fx2N D(Bit) [Pds] - KEP MMI-1500 Installation & Operation Manual

16.28 MITSUBISHI FX0n/2/2n COM, FX0n/FX2, FX2n, FX2n D(bit) [PDS]
16.28.1 HMI Setting
Communication parameters must be set the same as those of the PLC. The following settings are recommended.
Parameter Recommended Setting
PLC Type MITSUBISHI FX0n/2/2n COM
MITSUBISHI FX0n/FX2
MITSUBISHI FX2n
MITSUBISHI FX2n D9bit0
[PDS V1.00]
Serial I/F port RS485 4W
Baud rate 9600
Parity Even
Data bits 7
Stop bits 1
HMI station No. 0
PLC station No. 0
Comm. delay (10msec) 0
This driver supports Extended Address mode.
16.28.2 PLC Setting
Communication parameters must be the same as those of HMI (See recommendation above).
Compatible with:
Mitsubishi Models
FX0S FX0S-10 ~ FX0S-24
FX0N Series FX0N-24 ~ FX0N-60
FX0 Series FX0-14 ~ FX0-30Fxon
FX1S Supermicro FX1S-10 ~ FX1S-30
FX1N Supermicro FX1N-14 ~ FX1N-60
FX, FX2 & FX2C Series FX-16 ~ FX-128
FX2N Series FX2N-16 ~ FX2N-128
FX2NC Supermicro FX2NC-16 ~ FX2NC-96
BD Communication Module: FX2N-485-BD, FX2N-232-BD, FX1N-
485-BD and FX1N-232-BD
Note: PLC station number (0~15) must be set when using the BD
Module.
Register D8120 setting: Set bit 9 and bit 8 of BFM#0 as 0
Notes
Use with BD Communication Modules
mitsubishi(D_bit).pds driver must be present in \drivers folder
Options: RS232, RS485 2W, RS485 4W – Dependant on PLC
hardware
Options: 9600, 19200, 38400, 57600, 115200 - Must match PLC
port setting
Options: Odd, Even, None - Must match PLC port setting
Options: 7, 8 - Must match PLC port setting
Options: 1, 2 - Must match PLC port setting
Not used
Options: 0-255 Note: Must set PLC station when using a BD
Module
Request delay: 0~999 @10 milliseconds. Use when the PLC
requires a delay between requests. Not implemented in simulation
mode.
Touchscreen Driver
FXon/FX2
FXon/FX2
FXon/FX2
FXon/FX2
FXon/FX2
FXon/FX2
FX2n / FX2n D(bit)
FX2n / FX2n D(bit)
FX0n/2/2n COM
258