Idec Opennet - KEP MMI-1500 Installation & Operation Manual

16.13 IDEC OpenNET [PDS]
16.13.1 HMI Setting
This driver uses the same HMI and PLC settings and Wiring as the IDEC Micro
Parameter Recommended Setting
PLC type

Idec OpenNet

The following additional Device addresses are supported.
16.13.2 Device address
Bit/Word Type Address Format
B I
B Q
B M
B M8
B SR
B O
W D
W TV
W TP
W CV
W CP
W SRW
W MW
W MW8
W IW
W QW
W RTC
W OW
W LINK
Range
ddo dd: 0~59, o: 0~7
ddo dd: 0~59, o: 0~7
dddo ddd: 0~255, o: 0~7
dddo ddd: 0~23, o: 0~7
ddd ddd: 0~255
dddo ddd: 0~847, o: 0~7
dddd dddd: 0~1299
dddd: 2000~7999
dddd: 8000~8199
dd dd: 0~99
dd dd: 0~99
dd dd: 0~99
dd dd: 0~99
dd d: 0~15
ddd ddd: 0~127
dd dd: 0~11
dd dd: 0~29
dd dd: 0~29
d d: 0~6
ddd ddd: 0~423
dddd dddd: 100~1317
3
driver listed above.
Notes
idecONC.pds driver must be present in \drivers folder
Input Bits(X), word portion is decimal, bit portion is octal
Output Bits(Y), word portion is decimal, bit portion is octal
Internal Bits, word portion is decimal, bit portion is octal
Special Internal Bits, word portion is decimal, bit portion is
octal
Shift Register Bits
Link Relay Bits, Only available in processors that support
OpenNet
Data Words
Only available if expanded memory in processor
Special Data Words
Timer Values (read only)
Timer Presets if not redirected to a Data Word
Counter Values (read only)
Counter Presets if not redirected to a Data Word
Shift Register Words
Internal Bit Words
Special Internal Bit Words
Input Words
Output Words
Real Time Clock / Calendar Values (read as BCD only)
Link Relay Words, Only available in processors that
support OpenNet
Link Registers, Only processors that support OpenNet
231
Notes