Pvt Assembly - Polaris Magnum 2x4 Service Manual

CLUTCHES
PVT Assembly
5. Bend back retainer tabs on three screws at the front of
the inner cover and remove screws and retainer plate.
6. Loosen three inner cover retaining bolts at the rear of
the cover only enough to allow cover removal.
7. Remove cover. NOTE: Some covers (pre 1996) have
removable inner cover spacers. Do not lose spacers or
spacer retaining O-rings located on the outside of the
inner cover.
PVT Assembly
1. Inspect PVT inner cover seal. Replace if cracked or
damaged.
2. Use RTV silicone to ensure a watertight fit between
the seal and the cover. Surfaces must be clean to
allow proper adhesion of the silicone sealant. Allow
at least 12 hours for sealant to cure before
operating vehicle.
3. Make sure the spacers and O-rings are in place on
the inner cover rear bolts (where applicable).
4. Reinstall cover and tighten rear cover bolts just
enough to hold it in place.
5. Fit lip of inner cover seal to engine. Install seal
retainer plate and tighten screws.
10/96
6.10
Polaris Industries Inc.