Exhaust Pipe - Polaris Magnum 2x4 Service Manual

Exhaust Pipe
The exhaust pipe must be periodically purged of accumu-
lated carbon as follows:
1. Remove the clean out plugs located on the bottom of the
muffler as shown above.
2.
3.
4.
5.
6.
7.
8.
Place the transmission in neutral and start the engine.
Purge accumulated carbon from the system by momen-
tarily revving the engine several times.
If some carbon is expelled, cover the exhaust outlet and
rap on the pipe around the clean out plugs while revving
the engine several more times.
If particles are still suspected to be in the muffler, back
the machine onto an incline so the rear of the machine
is one foot higher than the front. Set the parking brake
and block the wheels. Make sure the machine is in neu-
tral and repeat steps 2 and 3. WARNING: SEE
BELOW.
If particles are still suspected to be in the muffler, drive
the machine onto the incline so the front of the machine
is one foot higher than the rear. Set the parking brake
and block the wheels. Make sure the machine is in neu-
tral and repeat steps 2 and 3. WARNING: SEE
BELOW.
Repeat steps 2 through 5 until no more particles are
ex~
pelled when the engine is revved.
Stop the engine and allow the arrestor to cool.
Reinstall the clean out plugs.
A WARNING
• Do not perform this operation immediately after the engine has
been run because the exhaust system becomes very hot.
• Because of the increased fire hazard, make sure that there are
no combustible materials in the area when purging the spark
arrestor.
• Wear eye protection.
• Do not stand behind or in front of the vehicle while purging the
carbon from the spark arrestor.
• Never run the engine in an enclosed area. The exhaust con-
tains poisonous carbon monoxide gas.
• Do not go under the machine while it is inclined.
Failure to heed these warnings could result in serious personal injury
or death.
Polaris Industries Inc.
2.33
MAINTENANCE
Chassis Maintenance
Clean Out Plugs
Clean Out Plugs
Clean Out Plug
;
g
~
"'" Clean Out Plug
Clean Out Plugs
5/98