Carburetor Assembly - Mikuni Cv - Polaris Magnum 2x4 Service Manual

FUEL SYSTEM/CARBURETION
Carburetor Assembly - Mikuni CV
1. Install the needle jet making sure the slot is aligned with
the tab in the jet block.
2. Install the main jet and washer.
3. Install the pilot mixture screw, spring, washer, and
a-ring as an assembly. Lubricate the a-Ring with oil or
light grease before installation. CAUTION: Do not
damage the a-ring during installation. Turn the screw
in until it
lightly
contacts the seat. Back out the
specified number of turns
1.
4. Install the pilot jet and pilot air jet.
5. Install the inlet needle seat with screen and a-ring.
Lubricate the a-ring with oil or a light film of grease.
6. Install the plate and retaining screw.
7. Install the float with inlet needle and install the pin.
CAUTION: Do not bend the float during installation.
1
NaTE: The final pilot (idle) mixture must be adjusted witr
the engine running. Refer to Page 2.12a.
5/98
4.36
Polaris Industries Inc.