Piston To Cylinder Clearance - Polaris Magnum 2x4 Service Manual

Engine Disassembly, Cant.
2. Record measurements. If cylinder is tapered or out of
round beyond .002, the cylinder must be re-bored
oversize, or replaced .
. . . . . .
StandardBQr~Size:
iEH42PL
~.4606~3.4614(87 .~O~87'.92ml'h)
i;1-I5Q,P;L,<r.. ... . . . . . . .....;
~~6~16~3.6~24(91~99;.~2+01
nlln)
Piston to Cylinder Clearance
1. Measure piston outside diameter at a point 5 mm up
from the bottom of the piston at a right angle to the
direction of the piston pin.
2. Subtract this measurement from the maximum
cylinder measurement obtained in step 5 above.
EloringLhriit:.020
(.5m.l1l)
Polaris Industries Inc.
3.63
ENGINE
EH42PLJEH50PL Engine
5/98