2X6 Hub Bearing Service; 2X4 Front Hub Installation - Polaris Magnum 2x4 Service Manual

BODY AND STEERING
2x4 Hub Bearing Service
2x4 Front Hub Installation
1. Apply grease to washer and install with spindle
nut. Torque nut to 40 ft. Ibs. (5.52 kg-m) and install
cotter pin. Tighten nut slightly if necessary to align
cotter pin holes. Rotate wheel and check for
smooth operation. Bend both ends of cotter pin
around nut in opposite directions.
2. Inspect O-Rings on hub cap for wear, cracks or
damage and replace if necessary.
3. Apply a light film of grease to hub cap and install
until fully seated.
4. Rotate hub. It should rotate smoothly without
binding or rough spots.
5. Install wheel and wheel nuts and torque evenly in
a cross pattern to 15 ft. Ibs. (2.07 kg-m).
7/96 5.28 Polaris Industries Inc.