FINAL DRIVE
Rear Drive Shaft
Rear Drive Shaft Removal
1. Lock the parking brake. Remove rear hub cap.
2.
Remove cotter pin.
3.
Loosen the hub retaining nut.
4.
Loosen - but do not remove - the wheel nuts.
5.
Safely support the rear of the ATV.
Serious injury could occur if machine tips or falls.
6.
Remove wheel.
7.
Remove inner drive shaft bolt.
8.
Slide drive shaft out of transmission splines. Lift
drive shaft up and toward center of ATV. Turn
bearing carrier down to disengage outer end of
drive shaft. Once drive shaft is free from bearing
carrier, pull out side of machine.
10/96
7.281
Polaris Industries Inc.