Cylinder Head Disassembly/Inspection - Polaris Magnum 2x4 Service Manual

Engine Disassembly,
C~nt.
1 . Remove the two 6x28 mm flange bolts from
cylinder head.
2. Loosen each of the four 11 x191 mm cylinder
head bolts evenly 1/8 turn each time in a
criss-cross pattern until loose.
3. Remove bolts and tap cylinder head lightly with
a plastic hammer until loose. CAUTION: Tap
only in reinforced areas or on thick parts of
cylinder head casting to avoid damaging
casting.
4. Remove cylinder head and head gasket. Note
the O-Ring in the corner of the gasket which
seals the front left cylinder stud. The O-Ring is
part of the fiber type gasket.
NOTE:This gasket has been superceded by an all
metal gasket which does not require an O-ring.
Cylinder Head Disassemblyllnspection
1. Thoroughly clean cylinder head surface to remove
all traces of gasket material and carbon. CAUTION:
Use care not to damage sealing surface.
Polaris Industries Inc.
3.51
ENGINE
EH42PUEH50PL Engine
5/98