Rear Hub Installation - Polaris Magnum 2x4 Service Manual

Installation
1. Start bearing carrier on drive shaft.
2. Align bottom of carrier housing and lower control
arm. Grease and slide lower control arm bushings
into place, securing corner housing.
3. Install and torque both lower control arm bolts.
4.
Lift bearing carrier until top aligns with upper control
arm. Install and torque upper control arm bolt and
torque to specification.
5. Pull drive shaft outward and install hub onto
driveshaft splines.
6. Install cone washer with domed side facing
outward.
7. Install retainer nut, wheel and wheel nuts.
8. Remove jackstand and torque axle nut and wheel
nut.
9. Install a new cotter pin. Tighten nut slightly to align
holes if required.
10. Install hub cap.
Polaris Industries Inc. 7.28k
FINAL DRIVE
Rear Hub - Shaft Drive
10/96