Polaris Magnum 2x4 Service Manual page 82

11. Adjust the dividers to a distance 3mm less than
the measurement recorded in Step 6. Set the
distance from the bracket to the lever arm tip (or
mark made in Step 5) by placing the divider points
in exactly the same location as in step 5. Loosen
lock nuts and adjust oil pump cable to new divider
dimension. Tighten lock nuts. Note: Adjustment
may change when oil pump cable adjuster lock
nuts are tightened. Verify the distance is 3mm
less than the recorded measurement.
12. Reinstall air filter, air box cover, and seat.
13. Turn throttle cable adjuster in (at throttle
housing) approximately 1 turn. Place
transmission in neutral, set parking brake, start
engine and let it idle.
14. Turn throttle cable adjuster out until engine RPM
starts to increase.
15. Turn adjuster in until there is 1/16" of throttle lever
movement before engine RPM begins to
increase. Tighten lock nut and slide boot over
adjuster.
16. Turn handlebars from left to right through the
entire turning range. If engine RPM increases,
readjust throttle cable free play and check for
proper cable routing.
5/98 2.19b
III. 7
MAINTENANCE
2 Stroke Engine Maintenance
Lock N
Distance must
be 3mm less
than recorded
measurement
Throttle Housing
1/16" Throttle
JL
Lever Free Play
Polaris Industries Inc.