Polaris Magnum 2x4 Service Manual page 504

Shaft Drive Transmission Assembly, Cont.
34. Make sure surface of access plate and transmission
are clean, and install bottom access plate with notch
to front as shown. Apply 10ctite™ 515/518 gasket
eliminator.
35. Using the Magnum crankshaft installation tool,
lubricate and install the front seal until flush with
housing.
36. Assemble Hi/Reverse assembly. Machined side of
circlip should face direction of thrust. Sliding shift
dog is symmetrical and can be installed either way.
The outer gear dogs must face each other.
37. Assemble the Hi/Reverse gear cluster as shown.
Polaris Industries Inc.
8.35
TRANSMISSION SERVICE
Type IV, Shaft Drive Transmission
10/96