Table of Contents
Advertisement
Carburetor Removal (Mikuni CV)
1.
Remove fuel tank on Gen II models.
Refer to
procedure on page 4.28.
2.
Remove seat and side covers. Loosen clamp at rear of
carburetor.
3.
Loosen clamps securing air box intake duct and PVT
intake duct and remove both.
4.
Remove air box retaining screws. Pull air box forward
to disengage rear mounting tabs and lift upward.
5.
Disconnect vent line from right side of carburetor and
slip oil tank vent hose under vent line. Set airbox aside.
6.
Remove two nuts securing rear of carb bracket to
dampers.
7.
Remove impulse line clamp and carefully remove line.
8.
Loosen carburetor flange clamp at front of carburetor.
9.
Remove carburetor. Place a shop towel in carb flange
to prevent dirt from entering.
10. Remove fuel line clamp and fuel line.
11. Remove choke assembly with cable attached.
12. Remove four screws from throttle shaft cover.
13. Hold cable adjuster and loosen lock nut. Turn adjuster
in if necessary to provide enough cable play to prevent
damaging the throttle cable during removal.
14. Lift throttle shaft.
15. Remove throttle cable from throttle shaft.
Polaris Industries Inc.
4.29
FUEL SYSTEM/CARBURETION
Carburetor Removal
5/98
Advertisement
Table of Contents
Troubleshooting
