Polaris Magnum 2x4 Service Manual page 450

Front Eccentric Installation
4. Install pinch bolt and lightly tighten to hold eccentric
in place.
5. Set chain tension and torque pinch bolt to 50 ft. Ibs.
6. Install spring washers and both drive shafts. Align
hole in U-joint yoke with hole in eccentric shaft, and
install new roll pin.
7. Install lower ball joint, torque nut to specification
and install new cotter pin. Install wheels and torque
wheel nuts to specification.
Polaris Industries Inc. 7.43
FINAL DRIVE
Front Eccentric
7/96