Polaris Magnum 2x4 Service Manual page 442

Center Eccentric Assembly
3. Install short end of shaft into bearing housing until
shaft bottoms on inner race of bearing.
4. Support bearing in housing with bearing installation
tool PN 2870676 or similar tool that supports outer
race of bearing.
5. Install other bearing using Magnum
PTa
end
crankshaft installation tool. Seat bearings
completely.
6. Install both end seals using seal and bearing
installation tool. NOTE: Do not support assembly by
housing. Support outer race of bearing, otherwise
seals and bearings may not be fully seated.
Polaris Industries Inc.
7.35
FINAL DRIVE
Center Eccentric
7/96