Ricoh D093 Service Manual page 556

SP1-xxx Feed
1 Length Level 1: Normal
2 Length Level 2: Normal
3 Length Level 3: Normal
4 Length Level 4: Normal
5 Length Level 5: Normal
11 Length Level 1: Cold Start
12 Length Level 2: Cold Start
13 Length Level 3: Cold Start
14 Length Level 4: Cold Start
15 Length Level 5: Cold Start
16 Length Level 0: Cold Start
Normally, pressure roller feedback control does not operate when the paper
length is not prescribed (length = 0). But if copying was started while feedback
control was not operating, during a cold start for example, then feedback control
operates using the setting of this SP code.
[0 to 300/15/1 sec.]
17 Length Level 0: False Start
The target hot roller temperature for a flying start is determined by SP1931. This
SP determines the time limit for the hot roller to reach that target hot roller
temperature.
[0 to 300/20/1 sec.]
18 Standby After Cold Start
This SP sets a time period that prohibits printing to begin even after the hot roller
temperature reaches its target temperature after a cold start. If a job is started
during this time period countdown, the countdown changes to the counts for-11 to
-17 above.
[0 to 300/60/1 sec.]
D093/D094
[0 to 300/15/1 sec.]
[0 to 300/30/1 sec.]
[0 to 300/45/1 sec.]
[0 to 300/60/1 sec.]
[0 to 300/80/1 sec.]
[0 to 300/20/1 sec.]
[0 to 300/35/1 sec.]
[0 to 300/50/1 sec.]
[0 to 300/70/1 sec.]
[0 to 300/100/1 sec.]
2-34 SM Appendix