SP2-xxx Drum
11 Cut Paper: Plain Paper: Image Area
[0.0 to 66/25/0.1 uA]
12 Cut Paper: Plain Paper: Image Area
[0.0 to 66/15/0.1 uA]
13 Cut Paper: Translucent: Image Area
[0.0 to 66/25/0.1 uA]
14 Cut Paper: Translucent: Image Area
[0.0 to 66/15/0.1 uA]
15 Cut Paper: Film: Image Area
[0.0 to 66/25/0.1 uA]
16 Cut Paper: Film: Image Area
[0.0 to 66/15/0.1 uA]
2801
Developer Initial Setting
This SP supplies some toner to the development unit, mixes the developer and
toner, and initializes the ID sensor. Execute this SP to mix the developer during
machine installation or after the developer has been replaced. The machine
requires two packs of developer. Two SP codes are provided for entering the lot
numbers of both packages.
Note:
Always enter the lot numbers with SP2801-2 and -3 before doing SP2801-1.
Execution of this SP requires that 2 kg of developer be loaded in the
development unit and that the toner cartridge be set.
If the lot numbers are not entered, then the developer cannot be initialized
(complete failure with no operation).
The Lot Numbers are stored in NVRAM.
Even if the Lot Numbers are the same, the number must be entered twice,
once for each packet.
Enter the Lot Numbers with the soft keyboard.
D093/D094
2-52
SM Appendix