Bit Switch 6 Settings Dfu - Ricoh D093 Service Manual

Main SP Modes
bit 5 DFU
If enabled, the image rotation will be performed according to specifications
bit 6 of older models (PCL: Pre-04A Models) for binding pages in mixed
orientation jobs.
bit 7 DFU
006

Bit Switch 6 Settings DFU

007 Bit Switch 7 Settings DFU
008 Bit Switch 8 Settings DFU
009 bit 0 PDL Auto Detection of Jobs Submitted via USB/IEEE1284
To be used if PDL auto detection fails. A failure of PDL auto detection does
not necessarily mean that the job cannot be printed. This bit switch tells
the device whether to execute a time out immediately (default) upon
failure or to wait 10 sec.
bit 1 Forced Printing
If enabled, the image will be printed regardless of whether the specified
roller for the correct size paper or not. This is similar to "Form Feed" on a
standard printer. Default: Enabled
bit 2 Job Cancel
If enabled, all jobs will be cancelled after a jam occurs.
Note: If this bit switch is enabled, printing under the following conditions
could cause problems:
D093/D094
Job submission via USB port or parallel port.
Spool printing: WIM> Configuration> Device Settings> System
6-108
- -
SM