Setting The Main Machine On The Roll Feeder (D503/D504) Or Table (B854) - Ricoh D093 Service Manual

Setting the Main Machine on the Roll Feeder (D503/D504) or Table (B854)

1. Do not remove the shipping tape from the connectors [1] of the roll feeder [2]. This prevents
damage to the connectors when the main machine is put on top of the roll feeder.
The main machine weighs 107 kg (235 lb.).
There are two handles in recesses on each side of the main machine. To prevent
injury or damage to the main machine, always use these handles [3] to lift the main
machine.
Two or more service technicians are necessary to lift the main machine and set it
on the roll feeder or table.
2. Lift the main machine, and set its rubber feet [4] into the holes [5] on the top of the roll
feeder or table [6].
With one person at each end of the main machine, use the two handles on each
end of the main machine to lift it.
3. Make sure that you put the rubber feet of the main machine into the holes on top of the roll
feeder or table.
4. Check the dehumidifier switch [7] of the roll feeder. Make sure that it is OFF. If it is ON, set it
to OFF.
SM
Main Machine Installation (D093/D094)
3-11 D093/D094