Toner Supply Mode; Long Print: Drawing - Ricoh D093 Service Manual

Main SP Modes

3 Toner Supply Mode

Sets the toner supply mode.
This SP sets the toner supply mode for toner supply control. This determines
the supply GAIN based on the ID sensor reading of the ID sensor pattern.
This determines the supply GAIN for the fixed toner supply mode for 3%
coverage and 6% coverage.
When fixed toner supply is selected, the image density is determined by the
rate of coverage in the image passing through the machine.
If the density of the image on the paper passing through is higher than the
rate set for the fixed toner supply mode, the image will be lighter.
[0 to 2 /0 / 1]
0: Detect Mode (uses ID sensor)
1: Fixed Mode (%3). Coverage fixed at 3% (medium)
2: Fixed Mode (6%). Coverage fixed at 6% (darker)
If the ID sensor is damaged and cannot be replaced immediately, set either
SP to "1". The operator can continue to use the machine until a new ID
sensor becomes available.
After the ID sensor has been replaced, reset the SP to 0.

5 Long Print: Drawing

The machine switches to the Long Print mode (fixed toner supply mode) for any
original longer than 1189 mm (46.8 in.).
There are two Long Print modes (Long Print/Drawing and Long Print
Graphic).
If the operator is frequently running jobs that contain either a lot of lines or
graphics then SP2208-7 (Long Print Mode Setting) should be set
accordingly.
The values set for this SP are reflected in the printed images after Long
Print/Graphic has been selected.
[1 to 40 / 3 / 1%]
D093/D094 6-18 SM